Microplex M204 Manuel télécharger pdf (Page 4)

05/13/97 4

M204 v5.7.2 Release Notes (Con’t)

6 Once the install process is complete, you will be prompted to view the

“ReadMe” ﬁle. Select “Yes” to read this and when done, close the

ﬁle.

7 Find the new IPAssign program group and double click on the “IPAs-

sign” icon to load the program.

8 At the “IPAssign” main dialogue box that appears, you should see an

entry for your M204 appear in the list box. If not, give IPAssign a

couple of minutes to ﬁnd the device on the network or repower the

device to speed the process. Figure 1 shows an example screen.

Figure 1: IPAssign Main Screen

9 Once your M204’s Ethernet address appears in the list box, select it

and press ASSIGN.

10 At the “Assign IP” dialogue box that displays next, ﬁll in the IP

address and subnet mask for this print server.

Note: You can also assign a default router/gateway entry

within this dialogue box allowing your M204 to

communicate across subnets. This is optional

though.

11 Click SET when done to assign these TCP/IP settings to the print

server. IPAssign will then display two dialogue boxes informing you

of its progress.

Once you see the message about successfully assigning the settings, click

OK. These TCP/IP settings are now in the M204’s current memory to be

retained until the next power cycle.

You will now need to store these settings into the device’s EEPROM to

ensure the settings are not lost after a power cycle. To do this, you will

need to:

1 Begin a Telnet session with the print server using the IP address you

have just assigned to it.

2 Log in as “root” when prompted for a login name and at the password

prompt, just press ENTER since there is no password by default.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Microplex M204 Manuel Page 4